|
Sheds

Permit Procedure
Location Requirements and
Specifications
Maximum Lot Coverage
Foundation Requirements
Required Setbacks and Lot
Coverage
Permit
Procedure
-
Submit a completed permit application.
-
Submit a copy of the plat of survey
showing the proposed location of the shed and the distance
from the lot lines and other buildings on the property.
-
A site check will be performed to verify
code compliance.
-
After approval, a permit will be issued.
-
If a contractor is used, s/he must be
licensed with the Village.
-
All concrete work requires a pre-pour
inspection.
-
A final inspection must be requested when
the shed is completed.
-
The shed permit is valid for 6 months.
Location
Requirements and Specifications
Please note that these specifications are general and not
comprehensive. Additional changes or suggestions may be
made by the inspectors during the site check to ensure that
the construction performed will be to code. Only one
shed shall be permitted per zoning lot. Shed must be
located at least five (5) feet from any structure, rear or
side lot lines and ten (10) feet from the house. It may
be located closer than ten (10) feet under certain
circumstances. The shed cannot be located on an
easement. A shed must be not more than one-story, shall
not exceed the height of the principal structure or twelve
(12) feet in height measured from the grade level of the
principal structure. The shed shall not occupy more than
30% of the required rear yard. All wood sheds must
conform to 2000 IBC and Village Code requirements including
2x4 nominal frame construction, 16" on-center with
interlocking double top plates and single bottom plates.
Splices must be located above wall studs. Any decorative
roof applications must provide proper flow through
ventilation.
Maximum
Lot Coverage
The total ground area occupied by any principal building,
together with all accessory buildings, shall not exceed
thirty-five percent (35%) of the total area of the lot.
The maximum size of a shed is 175 square feet.
Foundation
Requirements
The following table defines the type of foundation required
based on shed size. However, please note that all sheds
that are over 100 square feet in floor area are required to
have a concrete slab.
| Shed
Size |
Foundation
Required |
|
8' x 8' |
4" x 4" treated skids |
| 8' x 10' |
4" x 4" treated skids |
| 10' x 10' |
4" x 4" treated skids |
| 10' x 12' |
4" concrete slab |
| 12' x 12 |
20" wide by 14" deep continuous
concrete footing with 2 rebars |
| 12' x 14 |
20" wide by 14" deep continuous
concrete footing with 2 rebars |
References (revised 10/02)
*VC = Village Code
*IBC = International Building Code (2000)
Required
Setbacks and Lot Coverage
Please note that all detached accessory structures must
be located wholly in the rear yard (not permitted in corner
side yards), at least ten (10) feet from the principal
structure (house), five (5) feet from any lot line, or any lot
line or other structure must not
be located on any easement and cannot occupy more than thirty
percent (30%) of the required rear yard.

| Shed
Coverage Area = |
10’ x
15’ = |
150 sf
= |
8.3% |
| Rear Yard Area |
60’ x 30’ |
1800 sf |
|

Business
|
Government |
Services
|
Community |
Reference Desk
Site Map
| Search
|
Employment Opportunities | Home
Village of
Streamwood
301 E. Irving Park Road
Streamwood, IL 60107-3096
(630) 736-3800 |
 |
This page last modified
04/09/08 .
All information © 2008 Streamwood, Illinois
Site Use Policy
Site Design/Development by

|